Table of contents

  1. Electronics
  2. Tubing, connectors, etc.
  3. Silicones for casting in moulds
  4. Sheets for sealing

Here are some suggestions for commonly used materials. Some materials are expensive, are expensive to ship, or can only be ordered in bulk. It might be a good idea to team up with fellow students and order some materials together, to save on money. I’ve tried to find cheap materials, to keep pneumatics design accessible.

Electronics

For pumps, solenoid valves, air pressure sensors, microcontrollers, try shops like:

  • TinyTronics: link
  • RobotShop: link
  • Kiwi Electronics: link
  • Or at your own risk, Amazon and AliExpress.

Tubing, connectors, etc.

type order link
Silicone tubing, e.g. 8x5mm, 6x3mm, 3x1.5mm TinyTronics 5x3mm / rubberwebshop
TPU tubing, e.g. 6mm and 4mm RS 6mm TPU / RS 4mm TPU
heat-shrink tubing RS heat shrink for 6mm TPU tubing / RS heat-shrink for 4mm TPU tubing
Festo connectors, e.g. 6mm and 4mm RS Festo 6mm T-junction
Internal connectors (try aquarium shops) bol.com
60ml syringes luer-lock amazon.de

You can also use short pieces (approx. 20mm) of 8x5 silicone tubing to connect silicone and TPU tubes with a 6mm outer diameter!

Silicones for casting in moulds

Usually bought at FormX.
Try the less elastic DragonSkin 10, 20, or 30: link.
Or the more elastic Ecoflex 00-10, 00-20, or 00-30: link.
The numbers (10, 20, 30) indicate the shore hardness of the material. Look up a shore hardness table on the internet to get an idea of what these numbers mean.

Sheets for sealing

You can seal with the adapted Sovol printers, but you can also try sealing with your own 3D printer (if you have access to one) with just the printing nozzle heated up to around 270 degrees. See this resource for an example (scroll down): link.

Whatever you do, don’t try to seal or otherwise heat up or burn PVC sheets! This will release chlorine gas, which is very bad for your health. Check on the packaging what the material is. If you don’t know, don’t seal it!

type order link
TPU-coated nylon Extremtextil
TPU sheets bonoborepair
PU/PE sheets hornbach thin / hornbach thick

I only have Sovol sealing settings for the 70den TPU-coated nylon. For other thicknesses and materials you will need to tweak the settings to get the best results.



© 2026 Catharina Maria van Riet. Built with Jekyll and Just the Docs.

This site uses Just the Docs, a documentation theme for Jekyll.